Maximum Torque Specialists Cadillac Forums  

Go Back   Maximum Torque Specialists Cadillac Forums > Cadillac Tech > Everything Else

Everything Else non-engine or driveline Cadillac tech chat

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-20-2012, 02:06 AM   #1
The-Dullahan
Junior Member
 
Join Date: Mar 2012
Posts: 10
Default Belt Layout, Cadillac bigblock engines.

So after careful review, I have found that the standardized method of Bigblock Caddy belts is as such, with the rear belt lining up with the AC and power steering and the forward belt being spaced enough to match up with the water pump and alternator. Seen below.



However, and this is most likely due to the various layouts this engine can have, such as difference between years/actual engines as well as what had a smog pump and what did not, my balancer and water pump pulleys are a bit different. the two grooves in my lower pulley I suspect must be closer together and my water pump ALSO has two grooves.

Thereby, I have found that I can attach everything with three belts if I do it in this fashion (with my crudely drawn green, red and blue lines representing three different belts)



The blue one is the same as the first photo, connecting AC and Power Steering. The red one is to connect the water pump to the balancer and the green is to connect the Alternator to the water pump.

Think it will work? Any insight or input would be greatly appreciated.
The-Dullahan is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 07:07 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.